AO SERIES | INSTRUCTIONS MANUAL
32
4.4.2 Functions
The commands for driving the adaptive lens through serial interface are illustrated in
the following table:
TYPE
Serial
String
Command
Description
Example
Explanation
of example
DEVICE INFO
1
GET FIRMWARE
VERSION
Get the current FW
Version
DEVICE INFO
2
GET MAC ADDRESS
Get the MAC Address
of the device
DEVICE INFO
3 + IP
Address
SET IP
ADDRESS
Set the IP Address,
by writing it in the
non-volatile memory
3 192.168.1.1
Set the IP address equal
to 192.168.1.1
(This IP address will be
used after powering off
and on the device)
DEVICE INFO
4
GET IP
ADDRESS
Get the actual IP Address
OPERATION
10
TURN ON
THE LENS
Turn on the onboard
electronics
OPERATION
11
TURN OFF
THE LENS
Turn off the onboard
electronics
OPERATION
12
STAR LOOP
Start the automatic test
procedure
OPERATION
13
STOP LOOP
Stop the automatic test
procedure
OPERATION
14
ENABLE INPUT
CONTROL
Enable the lens control by
using the input pins
OPERATION
15
DISABLE INPUT
CONTROL
Disable the lens control
by using the input pins
OPERATION
16
ENABLE ANALOG
INPUT CONTROL
Enable the lens control by
using an analog signal
OPERATION
17
DISABLE ANALOG
INPUT CONTROL
Disable the analog lens
control
OPERATION
18
ENABLE DIGITAL
INPUT CONTROL
Enable the lens control by
using a digital signal (or
two digital signals)
OPERATION
19
DISABLE DIGITAL
INPUT CONTROL
Disable the digital lens
control
