Operation
Version 1.0.4 - 2020-09-08
48
Translation of original instructions
MZ2S
EN
MZ
2S
_G
B_4.
fm
4.18.2 Horizontal milling without counter-bearing
CAUTION!
Vertical milling with suitable clamping is always preferable to the horizontal milling
without counter-bearing, since the spindle protection has to be dismantled. Put the gear
switch for vertical milling to position "0".
Rotate the vertical milling head 90° so that the quill lever is up, and firmly clamp the clam-
ping lever of the quill.
Rotate milling head vertically on page 43
Disassemble the spindle protection for the quill.
Loosen the clamping levers ( 2 ) for the carriage on the milling head and move the carriage
of the milling head with a key ( 3 ) completely backwards.
Dismantle the protective cover ( 4 ) of the horizontal spindle.
Set the arbor (5) in the spindle, attach the counter-bearing ( 6 ), tighten the drawbar ( 7 ),
tighten the clamping screw ( 8 ) on counter-bearing.
Put the gear switch for vertical milling to position "0".
Vertical spindle gearbox switch on
2
3
4
7
