Safety
Version 1.0.2 - 2020-07-06
13
Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_1
.f
m
an adjustable spindle guard with position switch.
1.9.1
Emergency stop button
The drilling milling machine is equipped with an emergency stop button.
1.9.2
Protective cover
The spindle head is equipped with a pro-
tective cover.
WARNING!
Only remove the protective cover
when the mains plug of the drilling
milling machine is disconnected.
Img.1-1:
Protective cover
1.9.3
Main switch
In the "0" position, the lockable master switch can be secured against accidental or non-author-
ised switching on by means of a padlock.
When the master switch is switched off, the power supply to the machine is completely inter-
rupted.
Except for the areas marked by the pictogram in the margin. In these areas there might be volt-
age, even if the master switch is switched-off.
1.9.4
Cross table
Seats for T-slots are attached to the cross table.
WARNING!
Risk of injury due to workpieces flying off at high speed. Securely fix the workpiece on
the drilling table.
1.9.5
Drilling milling guard
Set the chuck guard to the required
height.
Close the drilling milling guard before
you start milling or drilling.
The drilling milling machine can only be
switched on if the guard is closed.
Img.1-2:
Spindle guard
1.9.6
Prohibition, warning and mandatory signs
INFORMATION
All warning signs must be legible. They must be checked regularly.
Protective cover
Drill chuck guard
