Version 1.0.2 - 2020-07-06
23
Translation of original instruction
DH 40CT | DH 40CTP
EN
D
H
4
0
CT_DH40CTP_G
B_3
.f
m
Make sure that the attached load does not cause damage to components or paint.
3.4.3
Assembly
WARNING!
Danger of crushing and overturning. The installation of the drilling milling machine must
be performed by at least 2 persons.
3.4.4
Installation
Check that the drilling milling machine foundation is horizontal with a spirit level.
Fix the foot of the drilling milling machine to the substructure with the provided through-holes.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights must be used.
3.4.5
Fixing
In order to provide for the necessary stability of the drilling milling machine connect the machine
with its foot to the substructure. We recommend the use of anchor rods DIN 529 M12 x 200
Fix the foot of the drilling milling machine to the substructure with the provided through-
holes.
Img.3-1: Fixing points
ATTENTION!
Tighten the fixing screws of the drilling milling machine only as much that it is safely
fixed and cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand of the machine.
Through-bore
605
405
