Opticon LG2 Series, Manual

Page: 16 / 113

LG2 User’s Manual 25-ULG2MU01-02 - 8
Save Settings
LG2 User’s Manual 25-ULG2MU01-02 - 9
Save Settings
2.1 - Installation Guide - USB Interface
To connect the LG2 to your host computer via USB interface:
1. Make sure the USB cable is sufficiently
attached to your LG2 unit (figure 2.1).
2. You DO NOT need to power off your host
computer (figure 2.2). The LG2 with
USB interface can be plugged into any host
while the computer is powered up.
3. Connect the USB interface cable to the host (figure 2.3). If you are unsure of
the proper location to connect the USB cable please consult the manual of
your host computer.
4. The USB interface does not require additional power supply. If you are using
the 1300 mA battery for batch mode, the LG2 will automatically recharge
the battery whenever the unit is a attached to a host that is powered up.
5. The LG2 will power on automatically.
6. Scan the following barcode to set the correct reader communication mode:
USB Keyboard Mode (Default)
7. Your LG2 unit should be ready for use. Open the application you wish to send data and
begin scanning.
Figure 2.1 Figure 2.2 Figure 2.3