Opticon LG2 Series, Manual

Page: 18 / 113

LG2 User’s Manual 25-ULG2MU01-02 - 10
Save Settings
LG2 User’s Manual 25-ULG2MU01-02 - 11
Save Settings
1. Power off the host computer.
2. Attach the end of the PS2 cable with the single connector to the LG2.
3. If external keyboard exists, unattach your keyboard from the host and connect the appropriate
connector to the PS2 cable .
4. Connect the other connector to host computer into keyboard port . The LG2 is
powered by the PS2 port and does not require a power supply.
5. Set the LG2 to PS2 mode by scanning the barcode below, then scan the Save Settings barcode:
PS2 Mode Save Settings
6. Your LG2 unit is now ready. Open the appropriate application and begin scanning data.
Upgrade Note: The PS2 model does not work with a USB cable. If you are upgrading the
firmware you must use a RS-232 cable.
WARNING: Opticon, Inc. does not recommend using Batch or Bluetooth Radio modes with the
PS2 interface because you need to disconnect the LG2 and the keyboard and this may result in
the host computer freezing and requiring you to reboot.
A
B
A
B
C
A
C
B
C
2.3 - Installation Guide - PS2 Interface
Opticon, Inc. does not guarantee compatibility with all models of laptops.