Opticon LG2 Series, Manual

Page: 76 / 113

LG2 User’s Manual 25-ULG2MU01-02 - 68
Save Settings
LG2 User’s Manual 25-ULG2MU01-02 - 69
Save Settings
6. The LG2 only supports the following symbologies:
MaxiCode, PDF417 (including Macro), Data Matrix, QR Code,
MicroPDF417, GoCode, UCC Composite, Aztec Code, Code 39,
Code 128, UPC/EAN/JAN,Int 2 of 5, Codabar, Codablock F,
Code 93, UCC RSS, POSTNET, PLANET, Japanese Post,
Australia Post, Royal Mail RM4SCC, KIX code
Why will my LG2 Bluetooth radio not connect?
1. Make sure the Bluetooth radio on the host device is installed correctly, turned on,
and ready
2. The LG2 Bluetooth radio is serial port profile only. Make sure the Bluetooth radio
on the host supports serial ports profile.
3. Scan barcodes on page 35 of the LG2 User’s Manual to set reader to correct
Radio Frequency (RF) communication mode.
How many LG2 Bluetooth units can connect with one host computer?
1. Only one LG2 can talk to one computer at any given time. However, the auto disconnect
mode allows the reader to automatically disconnect after sending its data.
This allows the next reader to make a connection, send its data and then disconnect.
Operating this way you can use multiple LG2’s with one computer. With multiple readers
trying to send data to the same computer there can be a slight delay from the time when a
barcode is read to the time when the data is sent to the computer. The delay can vary
depending on how many LG2’s are tying to connect at one time.
Note-The CodeXML Router software is needed to support this type of operation.
How do I keep the LG2 unit from losing its settings?
1. Scan the Save Settings on Reader barcode.
Why will my reader will not enumerate?
1. Make sure the reader is set to the correct USB communication mode by scanning
the appropriate barcode on page 35 of the LG2 User’s Manual.
What do the various beeps and lights emited by my reader mean?
1. Check the LG2 Feedback definition guide on page 44 of the LG2 User’s Manual.
11.5 - Frequently Asked Questions (con’t)