7
ZS-MDC
User’s Manual
In
trodu
ct
io
n
Introduction
Precautions for Correct Use
(3) Orientation when Installing the Multi-Controller
(4) Warming Up
After turning ON the power supply, allow the product to stand for at least 30 minutes
before use. The circuits are still unstable immediately after the power supply is turned
ON, so measured values may fluctuate gradually.
(5) Maintenance and Inspection
Do not use thinner, benzene, acetone or kerosene to clean the Multi-Controller.
Right
Wrong
Wrong
To improve heat radiation, install the Multi-Controller only in the
orientation shown below.
Do not install the Multi-Controller in the following orientations.
Summary of Contents for ZS-MDC
Page 12: ...10 Introduction ZS MDC User s Manual Introduction Editor s Note MEMO ...
Page 24: ...1 10 Section 1 FEATURES ZS MDC User s Manual Section 1 Part Names and Functions MEMO ...
Page 56: ...3 18 Section 3 SETUP ZS MDC User s Manual Section 3 Setting I O Assignments MEMO ...
Page 91: ...5 15 ZS MDC User s Manual Section 5 APPENDIX Section 5 Index MEMO ...