8
INTRODUC
TIO
N
Pre
c
au
tions
f
or Corre
ct
Us
e
CIDRW System
User’s Manual
INTRODUCTION
Please observe the following precautions to prevent failure to operate, malfunctions, or undesirable effects on
product performance.
About installation Site
Do not install this product in the locations subject to the following conditions.
• Place where direct sunshine strikes.
• Place with corroded gas, dust, metallic powder, and salinity.
• Place with condensation due to rapid temperature fluctuations.
• Place with condensation due to high humidity.
• Place where vibration and impact more than being provided by specification are transmitted directly
to main body.
• Place with spray of water, oil, and chemical medicine.
• The working temperature is within the range stipulated in the specifications.
About depositoty Site
• Store the Controller within the specified ambient storage temperature and humidity.
• Do not store the Controller in a location subject to rapid changes in temperature or condensation.
• Do not store the Controller in a location subject to direct vibration or shock outside the specified
range.
• Do not store the Controller in a location subject to combustible gases, explosive gases, corrosive
gases, dust, dirt, metal powder, or salt.
About wiring
• Use the power supply voltage specified in this document.
• Ensure correct polarity when connecting to the +/- power supply terminals.
• Do not run high-voltage lines and power lines though the same conduit.
• To avoid static-induced failure, wear a wrist band or equivalent means to release a static charge
before touching a terminal or a signal line within a connector.
• When you put on and take off a CIDRW head, please do not add excessive power to a connector.
• Please connect the correct CIDRW head to the amplifier unit.
Mounting
• Do not drop the Controller. Doing so may result in injury.
About cleaning
• Use alcohol to clean this product.
• Do not clean the Controller with paint thinner, benzine, benzene, acetone, or any other organic sol-
vent. These chemicals will dissolve the plastic materials and case coating.
Maintenance
• Perform inspections both daily and periodically.
Precautions for Correct Use
Summary of Contents for V640-HS61
Page 14: ...12 INTRODUCTION Reading this Manual CIDRW System User s Manual INTRODUCTION MEMO...
Page 120: ...118 SECTION 5 When SECS Is Not Used CIDRW System User s Manual SECTION 5 Troubleshooting MEMO...
Page 171: ...CIDRW System User s Manual SECTION 6 Protective Construction SECTION 6 Appendix 169 MEMO...
Page 173: ......