2-1
Section
Amplifiers
12
2. The NORMAL output signal is turned ON after the data is output.
3. When data in the Data Carrier fails to be read normally, the ERROR output
turns ON at the same time as the error classification is output with the data
output signal.
The write function has the following three modes:
1. BYTE Mode
1, 2, 3...
1. Data entered with the data input signal (16/8 bits) is written to the Data Carri-
er in the area specified by the address input,16/8 bit switch input, and write
area input.
2. After write processing is complete, the normal termination output signal
NORMAL is turned ON.
3. When data fails to be written normally to the Data Carrier, the ERROR output
turns ON at the same time as the error classification is output with the data
output signal.
2. BIT SET Mode
1, 2, 3...
1. Only the bits that are turned ON by the data input signal (16/8 bits) are set in
the area specified by the address input,16/8 bit switch input, and write area
input.
2. After write processing is complete, the normal termination output signal
NORMAL is turned ON.
3. When data fails to be written normally to the Data Carrier, the ERROR output
turns ON at the same time as the error classification is output with the data
output signal.
3. BIT CLEAR Mode
1, 2, 3...
1. Only the bits that are turned ON by the data input signal (16/8 bits) are
cleared to 0 in the area specified by the address input,16/8 bit switch input,
and write area input.
2. After write processing is complete, the normal termination output signal
NORMAL is turned ON.
3. When data fails to be written normally to the Data Carrier, the ERROR output
turns ON at the same time as the error classification is output with the data
output signal.
Write Function