[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
[ MAINTENANCE MENU ]
Quit
PT Setting
I/O Check
DIP-SW Status
Init. Memory
Memory Switch
Buzzer Sound
Bk light Off
Automatic Reset
ON
10min
Yes
Key Press Sound
ON
Quit
WRT&
EXIT
Page
97
Various System Settings
Section 3-8
3-8-5
Lamp Bit Control (NT20S-ST128)
When using the NT20S-ST128 (using the RS-232C interface for communication
with the host), you can select whether lamp statuses are controlled by bit designa-
tion or not.
The factory setting for this function is Enable (lamps numbered 0 to 31 controlled
by bits).
Set the lamp bit control function by the menu operation from the System Menu as
mentioned below.
Select “Maintenance Mode”.
Select “Memory Switch”.
Select “Page down”.
Summary of Contents for NT20S
