Omron NSA, Manual

Page: 45 / 114

3-2 Installing a PCI Board and Setting the DIP Switch
3-7
3
In
st
alling t
h
e NSA-
ser
ies I
n
dust
rial PC and Connect
ing Per
ipher
al Devices
3. Secure the PCI Board with the screw that was removed from the metal plate
cover in step 2.
Screw
Reattaching the Side Cover
Reattach the side cover and tighten the three screws that were loosened in step 1
to remove the cover.
Note
•
Use a PCI Board that complies with the EMC Directive. If a PCI Board that does not
comply with the EMC Directive is used, there are certain measures that the user
must take.
•
Be sure to turn OFF the NSA-series Industrial PC power supply (external power
supply) before you remove the side cover and install or remove a PCI Board.
•
Refer to the following diagram for mountable board sizes.
•
Check the PCI Board that will be used to make sure it operates properly prior to
actual operation.
•
The maximum power available at the two PCI Board slots is 5 VDC/2.1 A and
3.3 VDC/1.0 A, respectively.
•
There may be ambient operating temperature restrictions depending on the PCI
Board that is used. Make sure the Board is operating within the stipulated
temperature range.