Omron NSA, Manual

Page: 49 / 114

3-3 Installing the NSA-series Industrial PC
3-3-3 Connecting the Power Supply
3-11
3
In
st
alling t
h
e NSA-
ser
ies I
n
dust
rial PC and Connect
ing Per
ipher
al Devices
Note
•
The mounting panel must be between 1.6 and 4.0 mm thick.
•
Tighten the Mounting Brackets evenly to a torque of between 0.5 and 0.6 N·m to
maintain water and dust resistance. Make sure the panel is not dirty or warped and
that it is strong enough to hold the product.
•
Do not let metal particles enter the product when preparing the panel.
3-3-3 Connecting the Power Supply
Connect a 24 V DC power supply to the power terminals on the NSA-series
Industrial PC.
Note
•
Do not connect an AC power supply to the power terminals.
•
Do not perform a dielectric voltage test.
•
Use a DC power supply with minimal fluctuation range
•
Use an isolating source. Be sure to connect a DC power supply with reinforced
insulation to the NSA-series Industrial PC. The DC output side power supply should
not be grounded on one end.