![background image](http://html1.mh-extra.com/html/omron/grt1-27-11-2006/grt1-27-11-2006_operation-manual_742289061.webp)
42
Setup the GRT1-PRT Configuration
Section 3-3
3-3
Setup the GRT1-PRT Configuration
Setting up a PROFIBUS Master Unit to exchange parameters and I/O data
with the GRT1-PRT and the SmartSlice I/O System involves defining the I/O
configuration to the Master Unit and to set parameters needed at run-time.
Refer to
Appendix A PROFIBUS Technology
for more information on PROFI-
BUS network commissioning.
This section discusses the methods of configuration.
3-3-1
Defining the PROFIBUS Network
Defining the PROFIBUS network in the Cx-Profibus FDT Container, starts
with defining the PROFIBUS Master Unit and assigning the slave devices to it.
Defining and assigning devices can be achieved using drag & drop from the
Cx-Profibus Device Catalogue. Refer to the
CS/CJ-series PROFIBUS DP
Master Units Operation Manual
(W409) for more information on how to
assemble a network. The figure below shows Cx-Profibus with an assembled
network in the left window pane and the Device Catalogue opened in the main
window pane.
To define the I/O Configuration of the GRT1-PRT SmartSlice Communication
Unit, double-click the device in the Network view using the left mouse button.
A separate configuration window will pop up, which is described in the next
section.
Summary of Contents for GRT1 - 27-11-2006
