Omron CS1W-DRM21, Operation Manual

Page: 128 / 379

111
Remote Adapters Section 4-6
2. A multi-drop DeviceNet Connector cannot be used if the Hood Cover is
used.
Refer to the PCB Relays Catalog (X33) for details on the XG5 Loose Wire
Pressure-welded Connectors.
4-6 Remote Adapters
4-6-1 Node Address, Baud Rate, and Output Hold/Clear Settings
This section describes the Slaves’ node address setting, baud rate settings,
and hold/clear outputs for communications error setting. These settings are
made using the following pins on the DIP switch.
Node address setting: Pins 1 through 6
Baud rate setting: Pins 7 and 8
Output hold/clear setting:Pin 10 (affects only outputs)
Node Address Settings Each Slave’s node address is set with pins 1 through 6 of the Slave’s DIP
switch. Any node address within the setting range can be used as long as it
isn’t already set on another node.
0: OFF, 1: ON
Note 1. Refer to
Appendix A Node Address Settings Table
for a complete table of
DIP switch settings.
2. The Slave won’t be able to participate in communications if the same node
address is used for the Master or another Slave node (node address dupli-
cation error).
Baud Rate Setting Pins 7 and 8 are used to set the baud rate as shown in the following table.
(These pins are factory-set to OFF.)
8
ON
7 6 5 4 3 2 1
Baud rate setting
Node address setting
10 9
Reserved (Always OFF.)
Output hold/clear setting for
communications errors (for outputs)
DIP switch setting Node address
Pin 6 Pin 5 Pin 4 Pin 3 Pin 2 Pin 1
0 0 0 0 0 0 0 (default)
0 0 0 0 0 1 1
0 0 0 0 1 0 2
:
: :
:
1 1 1 1 0 1 61
1 1 1 1 1 0 62
1 1 1 1 1 1 63
Pin 7 Pin 8 Baud rate
OFF OFF 125 kbps (default)
ON OFF 250 kbps
OFF ON 500 kbps
ON ON Not allowed.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com