Omron C200H-TV001, Operation Manual

Page: 44 / 71

Distributor of Omron Automation & Safety: Excellent Integrated System Limited
Datasheet of C200H-DSC01 - DATA SETTING CONSOLE
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
41
I/O Data contents Data item Address
Bit Word
Input n+6 07 to 01 --- Not used. Each bit is set to 0.
00 Read
complete Bit set to 1 when the read operation executed by means of the
command set with Wd (n) ends normally. The bit is automatically
set to 0 when the next command is set.
n+7
15 to 12 Loop 1
executed
bank
number
Outputs the bank number currently executed for Loop 1 and Loop
2 as 1-digit BCD data.
11 to 08 Loop 2
executed
bank
number
07 to 02 --- Not used. Each bit is set to 0.
01 SW2-2 Outputs the ON/OFF status of SW2-2 (setting direction).
0: Data Setting Console
1: C200H PC
00 SW2-1 Outputs the ON/OFF status of SW2-1 (switching memory
contents).
0: Fixed
1: Normal
n+8 Loop 1
9 L 2
15 --- Not used. Set to 0.
Loop 1/2
t t d t n+9 Loop 2
14 Sensor
error Bit set to 1 if the sensor is not connected, a sensor
wire is broken, or the input data exceeds the
operational temperature range.
status data
13 CT
overflow Bit set to 1 when the detected heater current
exceeds 55.0 A.
12 to 09 --- Not used. Each bit is set to 0.
08 RUN Bit set to 1 during operation.
07 and 06 --- Not used. Each bit is set to 0.
05 Cooling
control
output
Bit set to 1 when the control output (transistor or
voltage output) is ON.
04 Heating
control
output
03 AT Bit set to 1 during auto-tuning (AT).
02 HB Bit set to 1 if the detected heater current drops
below the set heater burnout current value. (HB:
heater burnout)
01 AL1 Bit set to 1 when the temperature enters the set
l (R f t 23)
00 AL2
alarm range (Refer to page 23).
4-1-3 Table of Commands
The command codes shown below are set in bits (n Wd) 07 to 00 when the
SW2-1 (switching memory contents) on the front panel is set in the Normal posi-
tion.
Parameter Com-
mand
Write Read Loop
no.
Bank
no.
Actual data
range
Write/Read
data range
Default value
Set point 0 0 Yes Yes Yes Yes SV lower limit to SV upper
limit 0
°
C
Executed bank number 0 2 Yes Yes Yes No 1 to 8 0001 to
0008 1
Memory Allocation
Section 4-1
44 / 71
44 / 71