Omron C200H-CP114, Operation Manual, Page: 32 / 75

18
Data Setting and Monitoring Section 3-3
Monitor Items
Set the RUN/PRG selector to RUN.
Cam Setting Data and
Cam Outputs The following table shows the relation between the cam data that has been
set and the cam outputs.
The cam output turns ON at the ON angle and turns OFF at the OFF angle
minus 1
°
.
Cam outputs turn ON and OFF only when the Cam Positioner Unit is in opera-
tion.
The procedure for operating the Cam Positioner Unit is outlined below.
1,2,3... 1. Set the Cam Positioner Unit’s RUN/PRG selector to RUN.
2. Set banks 1 to 8 at word (n + 1).
3. Turn ON bit 00 of word n (Operation Flag).
(n = 100 + 10 x Unit no.)
During operation, the RUN indicator on the Data Setting Console will remain
lit.
Number of Revolutions
Required for a Single
Process and Monitoring of
the Number of Process
Execution Cycles The relation between the Mode 5 (number of revolutions required for a single
process) set value and the Mode 1 (monitoring of the number of process exe-
cution cycles) monitor value is as shown below.
If the number of revolutions required for a single process (i.e., the Mode 5 set
value) is “1,” then the monitoring of the number of process execution cycles
(i.e., the Mode 1 monitor value) will indicate the number of resolver revolu-
tions.
The Mode 1 monitor value will also indicate the number produced per unit
time.
MODE Name Function
1 Monitoring of the number of process execution cycles Displays the number of process execution cycles per
unit time.
2 Monitoring of the present cam angle Monitors the present cam angle of the resolver.
Cam output no. Step no. ON angle OFF angle
1 1 90 180
2 1 0 45
2 90 135
3 180 270
3 1 180 90
0
°
90
°
270
°
180
°
0
°
90
°
Angle of rotation
Cam output 1
Cam output 2
Cam output 3
Direction
of rotation
1 revolution
Mode 1 monitor value =
Number of resolver revolutions
Mode 5 set value