Installing the Display
Display Interface Unit 50 (DIU50) Installation
6-4
80-JB566-1 Rev. G
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
6.
Snap the display into the holster by placing the bottom into the lower holster tabs and
then push the top into the upper holster tab. It will snap into place.
7.
Route and connect the display cable to the VTM.
8.
Allow just enough display cable slack so the DIU50 can reach the driver steering wheel
only. Ensure any excess cable is secured and does not interfere with the operation of
the vehicle. Cable should not drape on the floor or cause a tripping hazard.
9.
Add a tiewrap strain relief to the DIU cable where it comes out from under or behind the
dash so it can’t be pulled out further.
WARNING
Excess cable can be a tripping hazard. Ensure cable is not draped where it will interfere with
either the driver or passenger as they move within the cab.
Caution
Never connect the MCP50 display cable and the power cable directly to each other. Only
connect these cables to the MCP50 VTM.