MF 64
Author: Donato Gavino Murru [email protected]
Pag.
169
a
179
Troubleshooting
Symptom
Probable cause
Item to check
Countermeasur
es
Interventions
mode
The final
shapes are not
stacked
Trip of stacking not
sufficient
The sides of
pusher
Increase the trip
Adjust on the axis
pages of stacker
The pieces
falling down
Before stacking.
The shapes are not
nicked on the scrap
Die cutting blade
of the cutting
press tool
Increase
number or size
of nicked parts
Using spring wire
or blade with
hammer
Some motor
brushless go in
error.
The shape are so
much attached to
the scrap
Shapes and
precutting phase
Change the
blades of the
cutting press
See chapter of
cutting press
Safety
Do not remove cover or carter without shut down the power. Before
operating with power to put again every security at good work.
Installation, operation, maintenance, or inspection must be performed
by authorized personnel. Not doing so may result in electric shock or
injury.
Do not touch any moving parts in operations or introduction hand . Do
so may result in injury.