CAUTION
CAUTION
CAUTION
NOTE
To match the existing structure, set the screw pitch according to the
product dimensions shown below.
Set using embedded appliances and embedded type of bolts.
Knife-type
insertion
piece
Sliding-type
insertion
piece
Reinforced bar
Embedded bolt
(hanging and embedded
bolt for piping)
Newly set concrete slab Structure
Directly set and use an angle steel for support.
Suspension
bolt
Angle steel
for support
Suspension bolt
Steel framework
Square bar material
Beam
Ceiling
Lifting bolt
Place the square bar by crossing the beams and set the lifting
bolts.
Use embedded bolts, embedded pull bolts, and embedded plug
columns
Wooden Structure
Original concrete slab Structure
All the figures in the manual explain only the general appearance
and dimensions of the unit. The air conditioner you purchased
may not be completely consistent with the appearance and
functions listed in the figures. Please refer to the actual product.
Figure 4
Figure 5
Figure 6
Ceiling
Main IDU body
53
71
90
105-160
840
840
840
840
230
230
230
300
A B C D E F G
Before IDU installation, make sure that the buffers used for
transportation between the fan and the pipe socket are removed.
Running the unit without removing the buffers may damage the
fan motor.
Make sure that the IDU body is level; otherwise, it may cause
water to leak. Calibrate the levelness of the IDU using a spirit
level or polyethylene tube filled with water.
The IDU is equipped with a built-in drain pump and float switch.
Do not tilt the unit in the reverse direction of the drain pan;
otherwise, the float switch may malfunction and cause water
leakages.
All bolts should be made from high quality carbon steel (with
galvanized surfaces or other rust preventive treatment) or
stainless steel.
How the ceiling is treated will differ with the type of building. For
specific measures, please consult the building and renovation
engineers.
How the lifting bolt is secured depends on the specific situation,
and it must be secure and reliable.
Do not place the panel such that it faces downwards or leans
against the wall. Do not place it on a protruding object either.
Do not hit or squeeze the air deflector.
There is an air vent shorter than the other three vents in the
panel. This air vent must match the shorter air vent of the unit
body (see the warning label on the unit body). Otherwise, it will
cause air leak and water condensation.!
680
680
680
680
Water discharge
pipe
Main body of air conditioner
5
Remove the air inlet grille.
Grille switch
45°
Press the two grille locks at the
same time to lift it up.
Raise the air inlet grille to about
45°, and remove the grille.
680
680
680
680
780
780
780
780
780
780
780
780
126
126
126
197
Main IDU body
53
71
90
105-160
105
105
105
105
70
70
70
70
H J K L M N
46
46
46
46
950
950
950
950
