Olympus oep-4, Instructions Manual

Page: 22 / 80

In
s
tall
a
ti
on and
Co
nnec
tion
2
2.8 Preparation of the Remote Control Unit (MAJ-898)
22
2.8
Preparation of the
Remote Control Unit
(MAJ-898)
CAUTION
• To protect the remote control unit (MAJ-898) against
damage, keep it away from liquids including water.
• When the remote control unit (MAJ-898) is not to be
used for an extended period, be sure to remove
batteries from it. Otherwise, battery fluid leak may
damage the remote control unit (MAJ-898)
• Should battery fluid leak, remove the leaked batteries,
wipe remaining fluid away from the battery
compartment and insert new batteries.
• Insert the batteries in correct polarities as indicated in
the battery compartment. Otherwise, the remote
control unit (MAJ-898) may not only malfunction but
may also be damaged due to battery fluid leak.
• When replacing batteries, be always sure to replace
both batteries. Do not mix a new and old batteries or
batteries of different types together. Otherwise, the
remote control unit (MAJ-898) may be damaged due
to battery fluid leak.
Remote control unit (MAJ-898)
The remote control unit (MAJ-898) can be used either as
a wireless remote or wired remote.
Preparation for use as a wireless remote
1
Slide open the cover on the back of the remote
control unit (MAJ-898).
2
Insert the provided two “AA”-size batteries as
shown in remote control unit (MAJ-898).
3
Attach the cover by sliding it.
Preparation for use as a wired remote
1
Insert batteries in the remote control unit (MAJ-
898) as described in “Preparation for use as a
wireless remote.”
2
Connect the provided remote cable across the
REMOTE 1 terminal of the color video printer
(OEP-4) and the cable connector of the remote
control unit (MAJ-898).
Figure 2.7
NOTE
If the remote cable is connected to either the REMOTE
1 terminal of this instrument or the cable connector of
the remote control unit, the remote control unit (MAJ-
898) will not function as a wireless remote.
Table 2.1
Use as a wireless
remote To remote control this instrument, point
the remote transmitter of the remote
control unit (MAJ-898) to the remote
sensor of this instrument.
The control range is about 3 meters
from this instrument, provided that
there is no obstacle between the remote
and this instrument.
Use as a wired
remote The wired remote control features
secure operation because control data is
transmitted to the instrument through
the remote cable.
The wired control is possible only from
within the reach of the remote cable.
Color video printer (OEP-4)
Remote control unit
(MAJ-898)
REMOTE 1 terminal
Remote cable
Cable connector