Car
e
, S
tor
a
ge
and
Dis
po
s
a
l
6
6.1
Care / 6.2
Displacement
63
6.1
Care
After using this instrument, immediately perform the
following cleaning procedure. If cleaning is delayed,
residual organic debris will begin to solidify, and it may
be difficult to effectively clean this instrument. The
color video printer should also be cleaned routinely.
WARNING
• If this instrument is wiped with a piece of moistened
gauze, dry this instrument thoroughly before use.
Using this instrument while it is wet may result in an
electric shock.
• During cleaning this instrument, always wear
appropriate personal protection equipment, such as
eye wear, face mask, moisture-resistant clothing and
chemical-resistant waterproof gloves that fit properly
and long enough so that your skin is not exposed.
Blood, mucus and other potentially infectious material
adhering to the monitor could pose an infection
control risk.
CAUTION
• Do not clean the terminals or the AC power inlet.
Otherwise, deformation or corrosion of contacts could
occur, which may result in contact failure and/or
malfunction of this instrument.
• Do not soak this instrument in water, autoclave or gas
sterilize it. Doing so will cause equipment damage.
• Do not wipe the external surface with hard or abrasive
material. The surface will be scratched.
• Minimize the opportunities of using neutral detergent
to clean the instrument. Also do not wipe this
instrument with too strong a force, as this may damage
the surface finish.
1
Turn the color video printer (OEP-4) OFF and
disconnect the power cord from the wall mains
socket outlet or mobile workstation.
2
To remove dust, dirt or other non-patient debris,
wipe color video printer (OEP-4) using a soft, lint-
free cloth or piece of gauze moistened with 70%
ethyl or isopropyl alcohol.
3
If the color video printer (OEP-4) is soiled with
blood or other potentially infectious materials, first
wipe off all gross debris using a neutral detergent.
Then wipe with a lint-free cloth or gauze moistened
with a surface disinfectant.
4
Make sure that the color video printer (OEP-4) is
completely dry before use.
6.2
Displacement
WARNING
Do not displace this instrument connected with the
power cord and/or connected cables. The power cord
and/or connected cables are damaged, electric shock
and/or fire may result.
CAUTION
• Displace this instrument after taking out the ink ribbon
holder and the paper tray. If not, damage to this
instrument may result.
• Do not displace this instrument with grasping the ink
ribbon holder insertion part and paper exit. Damage to
this instrument may result.
1
Turn the color video printer (OEP-4) OFF
according to the “4.4 Exiting from Examination” in
“INSTRUCTIONS (BASIC),” and disconnect the
power cord from the wall mains socket outlet or the
power supply socket of the mobile workstation,.
2
Take out the ink ribbon holder and the paper tray
from main body.
3
Remove connected equipment from the color video
printer (OEP-4).
4
Displace the color video printer (OEP-4). Install
and connect, referring to “Chapter 2 Installation
and Connection.”
Chapter 6 Care, Storage and Disposal
Summary of Contents for oep-4
Page 2: ...2 ...
Page 76: ...Index 76 Appendix ...
Page 77: ...Index 77 Appendix ...
Page 78: ...Index 78 Appendix ...
