67
6 Stereo measurement procedures (RX (stereo measurement function) only)
This mode allows for measuring the total length of multiple lines, each of which is specified by two
measurement points. When the specification of the last measurement point causes the first-drawn
line and last-drawn line to intersect, the area of the figure closed by the lines will be measured.
However, note that the measured area does not represent the precise area of the measurement
target but is only an approximate value obtained by dividing the figure into triangles. Up to 20 mea-
surement points can be specified per measurement session.
AREA/LINES
1
6
2
3
4
5
To move the cursor, tilt the [MEAS/ENTER] joystick in the desired direction.
Then, press the [MEAS/ENTER] joystick to specify the required number of
measurement points for each measurement method in the left image area on
the left side of the screen.
The measurement results and the object distance measured at the cursor
(distance between the distal end of the adapter and the measurement area)
are displayed.
In addition, the measurement result displaying "-. - - - mm", indicates that the
correct reference point was not automatically acquired.
Specifying and moving the measurement points
Select "CLEAR" in the measurement menu to delete measurement points specified by mistake.
Re-specifying a measurement point
Specification of measurement points
If you want to restart the measurement point specification in an image from the beginning, select
"ALL CLEAR" in the measurement menu.
Re-specifying all measurement points
Area/Lines
Measurement
point
Measurement point
Measurement
point
Measurement point
