DMTA-10055-01EN, Rev. A, February 2015
Chapter 11
230
To build a DAC curve
1.
Move the probe to the first echo.
2.
Press
G1 Start
(P5 key) and center gate 1 over the echo.
3.
Press
Add
(P1 key).
4.
Press 2
ND
F, (AUTO XX%) to activate AUTO 80 % for the indication.
You can press
Delete
(P2 key) to delete a point that is incorrectly acquired.
5.
Move the probe to the next echo and center gate 1 over the echo.
You can adjust the RANGE and DELAY while detecting the echo. You can also go
to the Trig menu item and adjust the
Angle
,
Thick
, and
CSC
parameters.
Once a point is captured, the peak amplitude of that point is marked using a “x”
symbol. Figure 11-4 on page 230 shows a partially completed DAC curve.
Figure 11-4 DAC Setup one point
6.
Press 2
ND
F, (AUTO XX%).
7.
Repeat capturing until a curve is built (See Figure 11-5 on page 231.)
8.
Press
Done
(P3 key).
Summary of Contents for EPOCH 650
