DMTA-10055-01EN, Rev. A, February 2015
Managing Special Waveform Functions
121
Figure 6-4 The x-axis grid modes
4.
Move the focus to the
Y-Axis grid Mode
parameter.
5.
Select the desired y-axis grid mode (see Figure 6-5 on page 122).
Standard
grid: traditional flaw detector view with
10 divisions equally spaced across the screen range,
and the numbers 1–10 appearing below each division.
Sound Path
grid: displaying actual sound path
measurements at equally spaced increments along the
horizontal axis. This mode displays 5 divisions, each
labeled with its corresponding sound path value
(depending on the
Basic > Range
,
Basic > Delay
, and
Meas Setup > Units
settings).
Leg
grid: displaying vertical lines representing angle
beam inspection legs. This mode displays up to 4
divisions, labeled
L1
to
L4
, which represent each half-
skip distance of a test piece during an angle beam
inspection. The spacing and number of divisions
displayed depends on the
Basic > Range
,
Basic >
Delay
, and
Trig > Thick
(material thickness)
parameters.
Summary of Contents for EPOCH 650
