Inside Edge of
Door Frame
Drill 1/2” Diameter Hole to
accommodate rod of Cane Bolt.
77.
Position and attach
Vertical Door Flange
on
inside edge of door frame
(left door from outside)
using
6 - 2” Screws
.
Parts
Interior Door Flange
(1/2” x 2 1/2” x 71”)
x 1
Hardware
S3
- 2” Screws
x 6 total
78.
The Interior
Cane Bolt
will be attached to Vertical Door Flange. To
position Cane Bolt correctly, attach to flange first, close doors and mark
hole to house Cane Bolt Rod. Open doors and drill hole where previously
marked with 1/2” bit. Attach Cane Bolt with 3/4”black screws.
Hardware
Y6
- Cane Bolt
x 1 total
SB1
- 3/4” Black Screws
x 6 total
79.
Attach
Door Handles
and Exterior Black
Drop Latch
to door. Attach Drop
Latch as illustrated above with
5 - 2” Black Screws
&
1 - 3/4” Black Screw
.
Note how female part of Drop Latch is positioned higher than male. Do a dry run
first to position Drop Latch correctly. Attach each Door Handle with
4 - 3/4”
Black Screws
, ensure screws connect with inner door stud.
Important:
Drill pilot holes with 1/8” drill bit prior to securing with screws to pre-
vent wood splitting.
Hardware
Y3 - Door Handles
x 2 total
Y4 - Drop Latch
x 1 total
SB1
- 3/4” Black Screws
x 9 total
SB2
- 2” Black Screws
x 5 total
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 42