![background image](http://html.mh-extra.com/html/olt/8x12-spacemaker/8x12-spacemaker_assembly-manual_732310017.webp)
23.
When all walls are attached together, check alignment with the floor. Bottom
of wall frames should sit flush with outside of floor framing, with siding overhanging
by approximately 1/2”. Confirm 64” wide door opening at bottom. When positioned
correctly, fasten Bottom Wall Plates to floor using
4 - 2 1/2” Screws
per wall panel.
Hardware
S1
- 2 1/2” Screws
x 36 total
Advice:
Prior to fastening walls and installing rafters, take time to confirm your walls are level, square and plumb.
Measure diagonal at top and bottom of walls corner-to-corner. This should be approximately 159 7/8”. More importantly,
if measurements are not within 1/4”, your walls are not square. Adjusting now will make it easier to install roof section
.
Optional
- Caulking
seams will help prevent
moisture from entering
your shed.
Caulking
not included in kit.
159 7/8”
159 7/8”
Angle
screws into perimeter
Floor Joists.
Pilot Hole
first.
64”
24.
Position
Rear Top Plates
on top of wall studs so they are flush on the inside. Together, the
plates should be centered evenly on the wall left to right. Attach by screwing down into top wall
framing with
3 - 2” Screws
per plate.
Parts (Steps 24 - 25)
Front & Rear Wall Top Plates
- 4 Angle Cut End, 2 Straight Cut
(3/4” x 2 1/2” x 32”)
x 6
Side Wall Top Plates
- Angle Cut Edge
(3/4” x 2 1/2” x 65 3/4”)
x 4
Hardware (Steps 24 - 25)
S3
- 2” Screws
x 34 total
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 17