17
T
RANSMITTING
A
DOCUMENT
FROM
THE
MEMORY
1. Place the original document in the ADF.
The display shows on the top line:
DOCUMENT READY
and on the bottom line, the default contrast value: NORMAL.
The initial resolution value (even if it is not shown on the
display) is: “
” (standard).
If you want, change the contrast and resolution values as
described previously.
2. Press the key
until the display shows:
TX FROM MEMORY
3. Press the key:
The fax machine starts to store the original document. Once
saved, the display shows the message “DOC.N. XXXX” for
several seconds.
TYPE TIME
HH:MM
For example “16:50”.
4. To do so, press the keys:
-
Confirm the entry or the current time.
5. To do so, press the key:
The display shows:
TYPE FAX NUMBER
NUM/TOUCH/SPEED
Dial your recipient’s number in any of the available methods:
directly on the numeric keypad or using the one-touch keys
or speed dialling codes (see “
Setting one-touch and
speed dialling
”).
6. To do so, press the keys:
-
7. Press the key:
The fax machine prompts you to enter another number:
TYPE FAX NUMBER
NUM/TOUCH/SPEED
If you want to send the document to more than one
correspondent, repeat the previous two steps for each extra
recipient.
8. To terminate the procedure, press the key:
9. If you want to send the document to one correspondent
only, simply press the key:
Once the procedure has been completed, the display shows:
AUTOMATIC 00
MEMORY TX
Note
If there is
a power failure
,
the transmission from the memory will
be cancelled
.
P
ROGRAMMED
TRANSMISSION
FROM
THE
MEMORY
CHANGING
,
REPEATING
OR
DELETING
1. Press the key:
until the display shows:
MEMORY TX
2. Press the key:
The display shows:
ALREADY ENTERED
3. Press the key:
The display shows:
PRINT SETTING?
You can choose the following options:
PRINT SETTING? – To print the memory transmission
parameters only. When it has finished printing, the fax
machine returns automatically to its stand-by status.
CANCEL SETTING? - To cancel the setting. The fax machine
returns to its initial stand-by status.
CHANGE PARAM.? – To change the recipient’s number or
the desired transmission time.
4. To select the other options, press the key:
/
5. To confirm the selection, press the key:
The display shows:
TYPE TIME
HH:MM
From this point on, proceed from Point No. 3 onwards of the
procedure in “
Transmitting a document from the memory
”.
