30 |
Page
Oliver Machinery
6303 Sander
Contour Sanding
1.
Loosen the dust chute lock knobs, then swing
the dust chute open to provide room for
inserting the contour sanding table.
2.
Re-lock the dust chute.
3.
Install the contour sanding table. Make sure
the table does not touch the abrasive surface,
and it is positioned at least 1/16” above the
bottom edge of the sanding belt.
4.
Tighten the table lock knob to secure the
table in place.
5.
Use the concaved abrasive surface for
contour sanding.
6.
Remove the contour sanding table and close
the dust chute when the operation
completes.
WARNING
Avoid sanding edges with curvature
closely matching the abrasive surface.
Failure to comply increases the risk of a
catch, which can cause severe injuries
and damage the workpiece.
IMPORTANT
Only open the dust chute and install the contour sanding table while performing
contour sanding. Keeping the dust chute closed at most times improves dust
collection effectiveness for edge/horizontal sanding, and reduces the risk of
accidental body contact with the sanding surface and moving parts.
Summary of Contents for 6303
