art. 1510
WARNING:
* always read the instruction before using power tools
* always wear safety googles
* wear hearing protection
OPERATING INSTRUCTION
1. Warning
1.1 Air pressure
The air pressure must be restricted at or less than maximum presure 90
psi (6.2 bar), do not exceed it.
1.2 Air line
Use an air hose between the compressor and the tool. The corresponding
hose internal diameter is recommended in the attached table in the data
sheet. Compressed air is cooled and its water content separated as soon as
the air leaves the compressor. However some of the water is condensed in
the piping, and can enter the tool mechanism and cause damage. An air filter
and on oiler should be installed between the compressor and the tool. Use a
recommended compressor in the date sheet or larger for each tool.
Code
Air inlet
Pad ø thread
Stroke
Free speed
Inner - Hose
Max. Air pressure
Air consumption Vibration (m/s2) Weight
617733
1/4"
150 - 5/16"
2,5 mm
10000 RPM
8 mm
6,2 bar
368 l/min
<2,5
1186 g
617713
1/4"
150 - 5/16"
5 mm
10000 RPM
8 mm
6,2 bar
368 l/min
<2,5
1186 g
1.3 Air hose
Clean the hose with a blast of compressed air before connecting
the hose to air tool. This will prevent both moisture and dust within
the hose from entering the tool an causing possible rust or
malfunction. To compensate for unusually long hose (over 25ft)
the line pressure should be increased accordingly.
1.4 Approved eye protection, mask, hearing protection and gloves
shall be worn when operate this tools.
1.5 The working place shall be ventilated.
1.6 Release the on-off device in case of air supply failure.
1.7 Release the start and stop switch in case of a failure of energy
supply.
1.8 Use only a lubricant recommended by the manufacturer.
Pneumatic sander
Содержание 1510
Страница 4: ......
