Oliver 4265, Owner'S Manual, Page: 49 / 70

4265 Jointer OLIVERMACHINERY.NET 49 | Page
Problem Possible Cause Possible Solution
Unable to lower
infeed table below
1/8”
Depth stop is
engaged.
Pull infeed table depth stop knob while lowing the
infeed table.
NOTICE: Only set depth of cut greater
than 1/8” for rabbeting operations.
Outfeed table is
loose and moves
with the fence.
There is play in
parallelogram
mechanism.
Check the parallelogram mechanism and eliminate
any gaps between the eccentric nut, bracket and
shafts. Ensure all eccentric nuts are locked by the set
screws, and each set screw is locked by blue Loctite.
Workpiece is caught
on the edge of
outfeed table.
Outfeed table is set
too high.
Adjust outfeed table to ensure it is flush with the
cutting arc of the cutterhead.
Uneven ware on
cutter inserts
One section of
cutterhead is used
more than another.
Occasionally adjust fence’s depth setting so the
entire cutterhead is utilized.
Machine vibrates
excessively or makes
unexpected noise.
Damaged cutter
inserts.
Replace cutter inserts.
Machine stands on
uneven floor.
Reposition machine on flat, level surface. Adjust
leveling feet.
V-belt worn, slipping
or hitting belt cover.
Clean belt and pulleys. Adjust belt tension. Replace
V-belt if it shows signs of aging.
Improper motor
mounting. Check and adjust motor mounting.
Loose components. Tighten fasteners of the component.
Worn bearings. Contact customer service for assistance.