Oliver 4265, Owner'S Manual, Page: 43 / 70

4265 Jointer OLIVERMACHINERY.NET 43 | Page
Infeed Table Adjustments
After a full table realignment, the infeed table
height should be re-zeroed, and a few
components of the infeed table will need to be
adjusted.
1. Disconnect jointer from power source!!
2. To re-zero infeed table height, raise the
infeed table so it is approximately at the
same height as cutting arc of the cutterhead.
3. Place a straight edge over the infeed table so
it hangs over the cutterhead.
4. Fine tune table height to set depth of cut to
zero. When properly set, cutters should be
barely scraping the straight edge when
cutterhead rotates.
5. With the infeed table height zeroed, follow
the steps in “ DRO Calibration ” to re-zero the
digital readout.
6. Check if the infeed table height scale is still
pointing at zero. If not, loosen the 2 hex
screws and readjust the pointer.
Infeed Table Depth Stops Adjustments
Under the infeed table, there are two positive
stops. One is for setting maximum depth-of-cut
for jointing, and another one is for making
finishing passes.
1.
Disconnect jointer from power source!!
2. With the depth stop knob left in place,
attempt to lower the infeed table beyond
1/8”. If this positive stop is set correctly, it
will stop the table at 1/8”.
3. If adjustment is needed, the stop nut is
located behind the depth stop knob, which
can be easily accessed when the panel is
removed. Loosen the jam nuts when making
adjustments.
4. The stop nut for finishing passes is located
below the infeed table, near the height
adjustment worm gears. This stop nut
should stop the table with 1/32” depth of cut.
Loosen the jam nuts when making
adjustments.