Oliver 4265, Owner'S Manual, Page: 45 / 70

4265 Jointer OLIVERMACHINERY.NET 45 | Page
Adjust Fence Positive Stops
The fence assembly has two positive stops at 90° and 45°. They were calibrated in factory and should not
require initial adjustments.
Adjust 90° Positive Stop
1. Loosen two jam nuts and positive stop set
screws.
2. Use a machinist square to set the fence at 90
degrees.
3. Rotate set screws to reset the positive stop.
4. With the set screws holding in place, tighten
the jam nuts.
5. Re-check fence stop settings.
Adjust 45° Positive Stop
1. Loosen jam nut and positive stop bolt.
2. Use a protractor to set the fence at 45
degrees.
3. Rotate stop bolt to reset the positive stop.
4. With the stop bolt holding in place, tighten
the jam nut.
5. Re-check fence stop settings.