Oliver 4265, Owner'S Manual, Page: 24 / 70

24 | Page Oliver Machinery 4265 Jointer
Wiring and Grounding
DANGER
Deenergize the electrical circuit before touching any enclosed, electrified parts.
Touching electrified part WILL result in serious personal injury or death.
WARNING
All electrical work must be done by a qualified electrician, and must meet the
electrical code in your area.
Make sure voltage of your power circuit matches the power requirement of this
machine, and the circuit is sized to supply power to the jointer.
Wiring Instructions
1. Power off before connecting any wires!!
2. Remove the screw that secures junction box
cover.
3. The wire connector inside the junction box
accepts hot conductors with ring/spade
terminals. The ground conductor can be
connected with wire nut.
4. Insert power cord through strain relief. The
strain relief can be temporarily removed
from junction box to make this task easier.
5. The picture below shows an example of how
a single phase 230V model can be connected
to a power source with ring terminal.
Please refer to the section “Wiring Diagram”
for connecting a specific model to power
source.
IMPORTANT: Always refer to local electrical
code for properly connecting any machinery
to power source.
6. Hand tighten sealing nut of the strain relief
to keep the cord in place.
7. Re-install junction box cover.