Oliver 10047VS, Owner'S Manual, Page: 32 / 58

32 |
Page Oliver Machinery 10047VS Shaper
Test Run
Each shaper has been inspected and calibrated before leaving the factory to meet our quality and
precision standards. To get familiar with all safety features and controls before using this machine for
production work, it is advised to complete the following test run. Please remove spindle, cutters and clean
up shaper table before running the following tests.
☐
Verify emergency stop button prevents unintentional startups.
1. Press STOP button.
2. Connect shaper to power source.
3. Press the green power button.
4. STOP button is not reset. Machine will not power on.
☐
Verify rotation direction switch has to be at OFF position when machine is powered on, and machine
can be reset.
5. Reset STOP button by rotating it clockwise until it pops up.
6. Set rotation direction switch to “FOR” position.
7. Press the green power button. The red ALARM light should turn on, and motor should not start.
8. Press STOP button or unplug shaper. Wait for 1 minute for the machine to reset.
9. Set rotation direction to “OFF”.
10. Reset STOP button and press the green power button, the green READY light should turn on. Set
rotation speed to the lowest, then rotation direction to “FOR”, and motor will start.
☐
Verify magnetic switch is functional for preventing unintentional restart after a power outage.
11. Continue from previous step, with motor running, unplug machine from power.
12. Reconnect machine to power source. Motor should not restart.
13. After setting rotation direction switch to “OFF”, press the green power button to turn on machine,
and “READY” light will come on.
☐
Verify rotation switch and speed dial are functional.
14. Continue from previous step, set rotation direction to “FOR”
15. The quill should rotate counterclockwise when looking down through the table opening.
16. Set rotation direction to “OFF”
17. Wait until the quill comes to a complete stop, then set rotation direction to “REV”
18. The quill should rotate clockwise when looking down through the table opening.
19. Change rotation speed from minimum to maximum. RPM display should show machine speed
goes from 5000 RPM to 9999 RPM. Reduce speed to minimum when finished.
20. Set rotation direction to “OFF” to stop the motor.
☐
Verify spindle elevator and digital readout are functional.
21. Move spindle to the lowest position.
22. Readings of digital readout should change when lowering the spindle, and spindle can be lowered
to 0” as indicated on the spindle height scale.
23. Reset digital readout and raise spindle all the way up.
24. Spindle should be able to raise to 4” as shown on the scale and digital readout.
25. Press STOP button to power off machine and complete the test.
Congratulations for completing the test run! If you discover any issue from the tests, please refer to the
troubleshooting section and maintenance section to diagnose issues and make adjustments.