Oliver 10047VS, Owner'S Manual, Page: 31 / 58

10047VS Shaper OLIVERMACHINERY.NET
31 |
Page
Installing/Removing Router Collets (Sold Separately)
Two optional router collets (1/4” & 1/2”) are available for this shaper. To purchase these collets, please
visit our website or call our parts department at 1-800-559-5065 .
WARNING
Disconnect machine from the power source before installing/removing collets.
Failure to comply may result in serious injury!
To Install Router Collet
1. Disconnect machine from power source!!
2. Lock spindle arbor.
3. Raise spindle arbor all the way up.
4. Hand thread the router collet onto the arbor.
5. Insert the router bit into the collet.
6. Tighten the collet with spindle wrench.
7. When collet is secured, unlock the spindle
arbor.
8. Rotate the collet to ensure cutter rotates
freely. Adjust fence, guard and use the right
table insert to create practically minimal
cutter clearance.
To Remove Router Collet
1. Disconnect machine from power source!!
2. Lock spindle arbor.
3. Raise the arbor all the way up.
4. Loosen the collet with the spindle wrench
provided.