Oliver 10047VS, Owner'S Manual, Page: 17 / 58

10047VS Shaper OLIVERMACHINERY.NET
17 |
Page
Inventory
Carefully unwrap the packaging and make sure all components are included in the shipment. Lay out all
items received and inventory them.
Item Description Quantity
1 8mm Hex Key 1
2 Screw driver 1
3 Starting Pin 1
4 1-1/4” Spindle Assembly 1
5 Wrench for spindle nut and spindle draw bar 1
6 Spindle draw bar 1
7 Miter gauge assembly 1
NOTICE:
If you cannot find an item in the list above, please check if it is still attached to the packaging or
inside the cabinet. Occasionally the item may have been pre-installed in factory. See section “
Parts List
”
to check if a component is included or installed.
NOTICE: This machine comes with various standard sized, non-proprietary parts. If any of these parts are
missing, we be happy to deliver them to you. To have the machine up and running as soon as possible,
you can also find these parts at your local hardware store.
Additional Items Needed for Machine Assembly
Item Purpose
Safety glasses Protection
Disposable gloves Protection
Paper Towel Cleaning
Rust Inhibitor Cast iron table top rust protection.
When all items are ready for setting up the machine, gently remove the machine from the pallet. Lift the
shaper with its table. If using a forklift or any metal lifting devices, ensure the table is protected by
paddings. Gently lower shaper on the floor to prevent damages to the casters.