Oliver 10047VS, Owner'S Manual, Page: 29 / 58

10047VS Shaper OLIVERMACHINERY.NET
29 |
Page
Install Shaper Cutter
WARNING
When changing cutters, disconnect the machine from its power source. Wear thick
leathers gloves to prevent hand injuries. Do not use damaged cutters, as it may
disintegrate during operation and cause serious injuries.
To Install Cutter
1.
Disconnect machine from power source!!
2. Lock spindle arbor.
3. Remove cap screw, spindle washer, keyed
collar, and extra spacers from the spindle,
then install shaper cutter.
4. IMPORTANT: Pay attention to the
orientation of the cutter blade. When
rotation switch is set to “FOR” (Forward), the
spindle will rotate counter-clockwise, and
vice versa. Operator should set up the
spindle assembly such that cutter rotation
direction goes against feed direction.
5. IMPORTANT: It is generally advisable to
place the cutter as low as possible on the
spindle to reduce spindle deflection. This
setup creates the best possible finish.
However, if cutter blades contact the base of
the spindle body, the cutter will need to be
raised with spacers.
6. After the cutter is properly inserted, Add
more spacers on top of the cutter.