Oliver 10047VS, Owner'S Manual, Page: 30 / 58

30 |
Page Oliver Machinery 10047VS Shaper
7. Then insert the keyed collar.
IMPORTANT: The keyed collar MUST sit
slightly ABOVE the top of the spindle. This
ensures significant pressure is applied to
hold down the cutter during operation.
8. Install spindle washer and the cap screw.
NOTICE: Spindle washer may or may not be
pronged. If a spindle is equipped with a
pronged washer, make sure the prongs are
inserted into the holes of the spindle.
9. Thread and tighten the cap screw with an
8mm hex wrench.
10. After cutter is securely installed, unlock the
spindle arbor.
11. Rotate the spindle to ensure cutter rotates
freely. Adjust fence, guard and use the right
table insert to create practically minimal
cutter clearance.