Oliver 10047VS, Owner'S Manual, Page: 18 / 58

18 |
Page Oliver Machinery 10047VS Shaper
Cleaning
To prevent rusting, the cast iron tabletop of this shaper
is covered with rust protectant and plastic film.
Remove both fence assembly lock knob to remove the
fence assembly. Then pull out the plastic film and wipe
off rust protectant with paper towels.
Once all rust protectant is removed, routinely coat the
table top with rust preventive such as Boeshield® T-9
or paste wax. Do not use rust preventives that contains
silicon, which is known to interfere with certain
finishes and glues.
Dust Collection
Shaper can generate a lot of wood shavings and dust.
Connect this machine to a dust collection system.
Minimum CFM requirement for this shaper is 800 CFM
at the dust port, which means your dust collection
system should have a rating greater than 800 CFM, as
air friction and leakage reduce effective CFM at the
dust port.
IMPORTANT
Running this shaper without dust collection system, or using a dust collection
system with inadequate suction, will cause dust and shavings to accumulate
inside the cabinet. This can damage the machine and cause other hazardous
situations. Check your dust collection system regularly to make sure it is not
jammed or filled up.
Moving / Leveling Machine
This shaper is equipped with casters so it can be moved easily. To keep the shaper in place, tighten the
caster locking knobs and lower the rubber feet.
If shaper is standing on uneven floors, use rubber feet to level the machine.