Upper Display
Lower Display
Function
FACTORY MODE
Sets up the Factory work mode.
This is a production mode.
Note!
The unit should always be set
for Shipping mode or erratic
operation may result.
FACTORY MODE
SHIPPING MODE
Sets up the Shipping mode for
normal operation.
BELT UNIT ******
Checks the FUSE status of the
transfer belt unit.
FUSE UNIT ******
Checks the FUSE status of the
fuser.
K-ID UNIT ******
Checks the FUSE status of the
K-ID unit.
Y-ID UNIT ******
Checks the FUSE status of the
Y-ID unit.
M-ID UNIT ******
Checks the FUSE status of the
M-ID unit.
FUSE INTACT
Note!
Indicates whether fuse is
INTACT or BLOWN.
C-ID UNIT ******
Checks the FUSE status of the
C-ID unit.
2.7.8 Engine Parameter Setting
This self-diagnostic menu is used to set Enable or Disable of error detections using
various sensors.
This menu enables service engineer to
Disable
or
Enable
the error detection
temporarily
.
When use of this menu is completed,
be sure to return the setting values to the default
.
1.
Enter the self-diagnostic mode
(Level 1)
and press the
(2) key
or
(8) key
until the
following message is displayed.
2.
When the (6) key is pressed, the following message is displayed.
Press the (2) key or (8) key until the desired item (refer to the table below) is displayed.
3.
When the (6) key is pressed, the setting values that are shown in the lower column of
the display window become selectable.
Pressing the (2) key increments the setting value. Pressing the (8) key decrements the
setting value.
4.
While the desired item to set is being displayed, press the (6) key for an extended time
(3 seconds) to register the displayed value in EEPROM. Screen returns to the item 2
condition.
Press the (4) key (excluding the condition of item 4) to exit the menu. (Screen returns to
the item 1 condition.)
44
