Menu Functions • 59
FRAME TYPE
AUTO
802.2
802.3
ETHERNET II
SNAP
Selects the Ethernet MAC layer frame
type.
IP ADDRESS
SET
AUTO
MANUAL
Change this to Manual to specify the IP
address through the front panel.(see
next entry) Required for non-DHCP
networks.
IP ADDRESS
xxx.xxx.xxx.xxx
Default =
192.168.100.100
Current assigned IP address. To
change:
• Press
ENTER
.
• Use
+
/
–
keys to increment first octet.
• Press
ENTER
to move on to the next
octet.
• Use
+
/
–
keys to increment second
octet.
• Press
ENTER
to move on to the next
octet.
• Use
+
/
–
keys to increment third octet.
• Press
ENTER
to move on to the last
octet.
• Use
+
/
–
keys to increment 1st octet.
• Press
ENTER
to register the new
address.
SUBNET MASK xxx.xxx.xxx.xxx
Default =
255.255.255.000
Current assigned subnet mask. To
change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx
Default =
192.168.100.254
Current assigned gateway address. To
change, proceed as above.
INITIALIZE
NIC?
[EXECUTE]
Initializes the network card.
WEB/IPP
ENABLE
DISABLE
Enables or disables Web config. facility
and Internet Printing Protocol.
This item will not appear in the menu if
TCP/IP is set to DISABLE.
Network Menu (continued)
Note:
Factory default settings are shown in
bold
.
Item
Settings
Explanation
Summary of Contents for C5400 Series
