Ohmeda Giraffe OmniBed, Operator'S Manual

Page: 40 / 54

3-12 6600-0342-000 08/08/01 3-12
Operating the OmniBed
Gas Cylinder Holder
The gas cylinder holder may be mounted on the outside or the
back of the dove tail accessory rails. Slide the holder down
from the top of the dovetail rail and secure it by tightening the
mounting nuts. On Giraffe models with the elevating bed height
option, always lower the bed to its lowest position before
mounting the holder to ensure adequate clearance with the
caster legs and the floor. Carefully place the cylinder in the
holder and secure it with the nylon straps.
Tubing Management Arm
The flexible tubing management arm aids in routing tubing to
the baby. It can be mounted by inserting it in any of the 4 “D”
shaped holes located at each of the bed corners. The slots and
holes in the tubing holder at the end of the arm accommodate
tubing of various sizes.
Note: The tubing management arm is designed for tubing only,
and will not support loads greater than 200 g.
Oscillator Port Cover
Use an oscillator port cover to close a port when the large
tubing of an oscillator is routed through it. A rim at the top of
the cover fits into the outer lip of the porthole seal, while tabs
on either side of the tubing slot fit under the seal lip to hold the
cover in position.