3-5
6600-0342-000 08/08/01
3-5
Operating the OmniBed
Additional Operating procedures
WARNING
w
w
w
w
w
When opening or closing the doors or
portholes, make sure the infant, any
clothing, monitoring leads, tubing,
etc., are completely within the con-
fines of the bed. Inspect all patient
connected tubes or leads before and
after sliding out, rotating, tilting,
raising or lowering the bed. Moving
the bed can pull on leads and tubing
which may disconnect tubes or leads,
restrict gas or liquid flow, or move
probes out of position.
Accessing the baby
To open the porthole, push the release button (A) and the
porthole will swing open.
To open the side door, pinch the latches together (B) to draw
back the bolts and lower the door.
To slide out the mattress tray, first make sure the bed is level and
grasp it by one of the holes. Pull the bed out toward you until it
stops (C).
To further access the baby, the mattress tray can be rotated in
either direction by grasping it’s edge and turning it (D). However,
the mattress tray must be pulled out or both doors must first be
lowered before the bed can rotate freely.
To raise the canopy, press the foot pedal or the switches at the
side of the bed near the uprights.
To lower the panel at the foot of the bed, pull it straight up and
then swing it out until it hangs vertically below the bed.
Note: The side panel at the foot of the bed can only be raised or
lowered when the canopy is raised.
CI.31.064
CI.31.065
A
B
CI.31.070
C
CI.31.071
D
Summary of Contents for Giraffe OmniBed
Page 1: ...GiraffeTM OmniBedTM Operator s Manual...
Page 24: ...1 20 6600 0342 000 08 08 01 1 20 General Information Notes...
Page 28: ...2 4 6600 0342 000 08 08 01 2 4 Preoperative Checkout Procedure Notes...
Page 48: ...4 8 6600 0342 000 08 08 01 4 8 Maintaining the OmniBed Notes...
