OHD QuantiFit 2, Manual

Page: 21 / 110

Onboard Settings
20
System settings
Cylinder Test Mode
is used for demonstration
purposed or validation testing.
Volume allows the operator to increase or decrease
the volume of the audio indicators that one might
hear when testing or entering test data. The settings
are 0 to 10, where 10 is the loudest.
Brightness allows the operator to increase or
decrease the brightness of the display. The settings
are 1 to 10, where 10 is the brightest.
Auto Print is turned on when the operator desires
the test automatically to be printed upon completion
of a fit test.
Number of Prints allows the operator to select the number of prints when printing reports. To
be used when more than one copy is required.
Auto Advance will automatically advance to the next step after a step has passed successfully. If
the test step fails , the operator will be given the option to retry the step or advance to the next
step. The auto advance feature may be turned off, and the operator must then select the arrow
button for the next step, or the retry button when a retry is necessary.
Auto Advance Time allows the operator to set the time given before the test step advances to
the next step when the auto advance function is turned on.
Redon Delay is the number of seconds to delay the QuantiFit2 while the test subject redons the
respirator so that auto start is not analyzing samples while the redon is taking place.
Signature Capture allows the operator to turn off the signature capture at the end of each test
if the signatures are not necessary or required.
System Information
The information button will display helpful information when contacting OHD for support
including:
o
System Version – The current version of on-board software
o
Cycle Count – The number of cycles the instrument has run
o
Calibration Due Date – The date due for annual calibration requirements
o
Current Date – Can be changed by touching the current value