CHAPTER 3 MAINTENANCE PROCEDURES
Ohaus Corporation www.ohaus.com 24
Adventurer ™ Balances Service Manual
4. Remove the balance top housing by firstly lift the back of the housing upwards as shown in
below picture.
Figure 3-8 Side view of Adventurer Balances.
Lift the back of the top housing upward.
Figure 3-9 Lifting up the back of Adventure top housing.
Then slide the top housing upfront as shown below.
Figure 3-10 Sliding Adventurer Top Housing upfront.
NOTE: Now you can gently lift the top housing from the bottom housing but you have to
be careful, do not remove the top housuing completely away from the bottom housing
because at this point the TFT LCD and Keypad membrane cables are still attached to the
balance main PCBA as shown on the next page (Figure 3-11).
Figure 3-11 Location of TFT LCD and Keypad membrane cables.
Note: Make sure you
remove the screw
from the LFT
compartment.
