Effective April 2006
33
Touchscreen General Introduction
(This is an optional control center and may not be included on your machine)
Before running the Generator be sure to look through the user manual on the
follow pages. General information on button usage, and screens is listed below.
Please read carefully.
Initially there must be power supplied to the generator.
Once there is power to the generator the screen will need to boot up. At first there will
be many errors on the bottom of the screen do not worry about the warnings as of yet.
As you already know the generator needs to be cycling for at least 15 minutes before it
begins to function properly.
Once that phase is over the Language screen will be the first viewable screen.
English is the default language, Spanish is available, and French is an option upon
request. Any one of these buttons may be pressed as per the language that is
appropriate for the user. Once one of these buttons has been selected, and the go to
the Security Screen Button has been touched, the Password Screen will be active.
The user must touch the yellow password area, to get a numeric entry system in
which the user must enter their password. After the proper password is entered, the
next screen will appear. OGSI will supply you with your own password, specified upon
your request.
The next screen is the Control Screen. This screen contains the modes of
operation, and indicator buttons. For the machine to start cycling one of the Mode of
Operation Buttons must be selected, either Continuous or Automatic. There are
indicator lights on the screen that are explained above. Once that has been taken care
of, you will be ready to move onto the next screen which is the main screen.
The Main screen contains the adjustable pressure switch for the machine. If you
are running the Generator in Automatic mode it is possible to adjust the pressure
switch. The only way to do this is to deactivate the SET DEFAULT FOR PRESSURE
SWITCH. If that touch area reads Off, you may proceed to adjust the Default
Pressures. If the area reads On, all that has to be done is to touch the Green Area.
Once that has been taken care of the touch area should be red, and the words OFF
centered on the button. Note: That the value in SET LOW POINT FOR PRESSURE
SWITCH must be less than the value in SET HIGH POINT FOR PRESSURE SWITCH.
If this condition does not hold true the machine stops cycling, and errors will begin to
pop up. If this error does occur change the Pressure Switch settings immediately. If
this is not taken care of immediately the machine will stop cycling. Recommended
areas for the Pressure switch is to have a 17 psi difference between high and low
points, and the default is 45 (low) psi and 62 (high) psi. There is also a real time clock
on this screen, which can be adjusted by 1 hour either up or down.
Summary of Contents for OG-75
