Effective April 2006
28
Oxygen Out -
The Oxygen Outlet Connection is on the right hand side of the machine. There is
an appropriately sized fitting to which the GREEN interconnecting Oxygen Hose
Assembly should be attached. This Oxygen Hose Assembly has a female
threaded fitting that swivels on each end of it. The other side of this Oxygen
Hose Assembly should be connected to the inlet fitting of the Oxygen Storage
Tank that you are using. If the storage tank was purchased from
OGSI
, it will
have an appropriately sized fitting in place for this connection. If the tank was not
purchased from
OGSI
, you must insure that it has
the appropriate size fitting
to accept the hose assembly
Power Cord -
On generators sold within North America, this cord can be plugged into any
standard 120 VAC/60 Hz electrical outlet. The generators do not draw much
current (less than 1 amp) and have internal protection for short circuiting (either a
fuse or circuit breaker depending on which model you have).
Generators shipped outside North America will have an electrical plug suitable
for use in the location to which it is shipped or have bare wires ready to accept
such a plug. Typically, this will be a three-pronged jack intended to accept a 220
VAC/50 Hz supply but may vary as required.
Manual Drain Switch -
The manual filter bowl drain can be used at any time to empty the contents of the
filter bowl and is especially useful during the filter element replacement
procedure. It is a momentary switch so it will only hold the drain valve open as
long as it is pressed. Upon release, it returns the valve to its normally closed
position. This button has a rubber cover protecting it from external
contamination. Do not attempt to remove this cover.
Filter Drain Hose -
A small hose is provided with each unit and can be run directly into a drain. This
hose will alleviate the potential problem of having water and material trapped by
the filter blown directly on to the floor. Using this hose/connection is strictly up to
the user.
Summary of Contents for OG-75
