Clamp pincer CP 10 / CP 20 / CC 20
5
Use of clamp pincer
NOTICE
•
When the battery is low, the pincer will not perform closures.
•
This display should be used only to indicate the level of charge remaining.
•
The battery can stay in clamp pincer CP 10 / CP 20 / CC 20 to test the level of charge. In order to avoid
uncertainty about the accuracy of the reading, however, clamp pincer CP 10 / CP 20 / CC 20 must be
switched off for at least 1 minute prior to the test.
5.2.2 Charging battery
INFO
Further information about the battery charger can be found in the supplied operating instructions from
Techtronic Industries GmbH.
1. Connect charger (Fig. 10/2) to power supply.
2. Attach battery (Fig. 10/1) to battery charger.
3. Remove battery (Fig. 10/1) from the battery
charger as soon as it has reached the desired level
of charge.
4. After charging, disconnect the battery charger
(Fig. 10/2) from the power supply.
Fig. 10:
Charging the battery
5.2.3 Inserting battery
CAUTION
Risk of injury due to accidentally pressing the START button!
Once the battery has been inserted, the pincer is energized. If the START button is pressed (even
accidentally) the pincer jaws will close!
Ensure the START button is not pressed accidentally.
Issue 11.15
08902961
5-24
