Clamp pincer CP 10 / CP 20 / CC 20
4
PC software & firmware
Issue 11.15
08902961
4-14
4
PC software & firmware
4.1
System requirements
The PC on which the software is installed must satisfy at the following requirements:
•
Computer:
Pentium 4 processor or equivalent – CPU at least 1.7 MHz
•
Graphics:
Screen resolution min. 1024 x 768 pixels or higher,
65535 or more colors
•
Main memory:
512 MB RAM or more (1 GB recommended)
•
Hard drive:
200 MB free disk space (1 GB recommended)
•
Screen resolution:
1024×768 or higher, 65535 colors or more
•
Operating system:
Windows Vista
®
, Windows 7
®
and Windows 8
®
•
Other:
CD-ROM drive, USB 2.0
Installation notes
The program must be installed and started up for the first time by someone with adequate user rights. If an error
message appears during installation or on initial startup, please contact your system administrator.
Plug & Play
After the PC software supplied has been installed and clamp pincer CP 10 / CP 20 / CC 20 is connected to the
PC via the USB cable, the computer automatically recognizes the pincer. When connected for the first time, this
recognition of the clamp pincer may take a few minutes. Upon recognition the PC software can be used.
4.2
Installing the PC software
INFO
The following descriptions assume a basic knowledge of how to use a PC with the Windows operating
system.
4.2.1 Automatically installing PC software
1. Close all open applications.
2. Place the CD in the CD-ROM drive.
After a few seconds the installation instructions will be displayed on the screen.
3. Follow the instructions on the screen.
